All posts by Jestine Yong

  • XBOX 360 Repair

    I came across these two ebooks that offer solution on how to repair xbox 360 that have the problem of three red lights. These ebooks claims that you can repair the 3 red lights in less than...

    • Posted September 15, 2007
    • 6
  • Replacement resistor for Analog multimeter

      If you are using analog multimeter and experienced not accurate result especially using the X1 ohm scale, i suggest that you open the cover up and see if there is any resistor burnt. When this X1...

    • Posted September 15, 2007
    • 0
  • Technology- Cutting Laser

    It can cut through steel, plastic and etc-Enjoy! Likes(0)Dislikes(0)

    • Posted September 14, 2007
    • 0
  • Bdent Electronic Supplier

    Here’s another electronic suppliers that offer semiconductor parts for electronic repairer-Bdent dot com. They also have variety range of other electronic components too. Feel free to check out the website. Likes(0)Dislikes(0)

    • Posted September 14, 2007
    • 0
  • Update and Upgrade Yourself

    No matter what kind of jobs you are doing right now whether is technician, engineer, designer, programmer and etc you need to constantly update and upgrade yourself in order to improve your skill and knowledge. With additional...

    • Posted September 13, 2007
    • 0
  • How To Reprogramming 93c56

    How to reprogramming 93c56 eeprom ic is not difficult. What you need is a eeprom programmer and the master copy of the software. If you knew that this particular model of equipment the eeprom always have problem...

    • Posted September 13, 2007
    • 1
  • Monitor Repair Manual

      At the beginning, you need to depends on monitor repair manual to understand how Monitor circuits work. After you had familiarize how it works, i suggest that you  depends lesser on monitor repair manual. By constantly...

    • Posted September 13, 2007
    • 30
  • Shorted Diode Test

    The best to test a diode is to remove one lead from the electronic board. Set your analog meter to X 10 k ohms and place it on the diode either way. A good diode should show...

    • Posted September 12, 2007
    • 0