- No Power In Vitron LED TV Repaired
- MAP3202 LED Driver IC Failure In 42″ LED TV
- LG LED Television Model 32LB561U Dead, Power On LED Red Now Repaired
- Power Blinks In LG LED TV Repaired
- Shorted LED Driver Mosfet In Hisense LED TV Repaired
- Restored Philips LED TV Fully Water Logged In Floods
- Samsung Smart TV Powering On/Off
- Blinking Stand By LED Light In LED TV Repaired
- No Tuning Problem In LED TV Repaired
- Sanyo DP40142 LED/LCD TV Repair
Canon MG 5450 Printer Repaired
I work at copyshop and we have a Canon MG5450 printer who is used to print on CD and DVD. After 8500 printings, error 5B00 occur that’s mean the waste ink pad is almost full. This is a protection counter to prevent ink leak.
In this case i have to clean or replace the waste ink pad. I chose to clean them. Let’s start the job. Disassembling is very easy: no screws just clips.
After disassembling the lateral, two screws and remove the scanner assembly (be careful at the scanner connections with the motherboard). Lift up the scanner and you will see the waste ink pad.
As you can see in the photo the waste ink pad is almost full. One screw and the pads are removed. After cleaning you must dry them and put it back. Assembling the printer back, but surprise! The error still occurs. The waste ink counter and other information are stored in the EPROM. Now is time to reset the waste ink counter.
First we need to enter in service mode: press and hold the power button, then press for five times resume stop/button and release the power button. Connect the printer to computer and run Canon service tool V 3400, select the region and press waste count reset. After few seconds the counter is reset. Turn the printer off and then on. Now the printer is work again.
This article was prepared for you by Mihai Mazarus from Brasov Romania. He works in a copyshop and his hobby is electronics repair.
Please give a support by clicking on the social buttons below. Your feedback on the post is welcome. Please leave it in the comments.
P.S- If you enjoyed reading this, click here to subscribe to my blog (free subscription). That way, you’ll never miss a post. You can also forward this website link to your friends and colleagues-thanks!
Note: You can check out his previous repair articles in the below link: