Comments on: A Bike Control Board That Had A Part Ripped Off Board Restored

By: Waleed Rishmawi

Waleed Rishmawi — Mon, 07 Oct 2024 05:30:37 +0000

Yogesh: yes I had to use the microscope and fine soldering tip I was able to put it back and added a soldering mask on the top of it for protection. have a blessed day

Likes(2)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Mon, 07 Oct 2024 05:28:31 +0000

In reply to Imoudu.O.

Imoudu: not sure since the customer brought the replacement for it no even the original part but I think it was a power IC. have a blessed day

Likes(0)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Mon, 07 Oct 2024 05:27:00 +0000

In reply to Mark J.

Mark: the deal with the customer was it is works or did not work it is not our responsibilty; either way my friend nor the customer got in touch with me conering that. have a blessed day

Likes(0)Dislikes(0)

By: Yogesh Panchal

Yogesh Panchal — Sun, 06 Oct 2024 10:44:44 +0000

Waleed, such jobs are very difficult without good soldering iron & Microscope.
& also it is good practice to charge a customer for the time & material spent.

Likes(0)Dislikes(0)

By: Imoudu.O

Imoudu.O — Sat, 05 Oct 2024 21:48:20 +0000

What type of component did you solder back?

Likes(1)Dislikes(0)

By: Mark J

Mark J — Sat, 05 Oct 2024 19:29:50 +0000

Waleed maybe your friend will get back to you and let you know if it is working. Well done on the repair.

Likes(0)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Sat, 05 Oct 2024 14:06:35 +0000

In reply to Parasuraman S.

Parasuraman: I cleared it up although i explain its self if you read carefully the beginning the article that a deal was done with the customer to re solder the part back on board but we are not responsible if that board is working again or not. Have a blessed day

Likes(0)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Sat, 05 Oct 2024 14:01:35 +0000

In reply to Albert van Bemmelen.

Alber: if you read in the beginning of the article, we have made a deal with the customer to install the missing part but we are not responsible if the device worked or not since was bike was out of reach at that time. The part was restored on board but I did hear about it ever since. Have a blessed day

Likes(0)Dislikes(0)

By: Parasuraman S

Parasuraman S — Sat, 05 Oct 2024 11:24:05 +0000

Good job there, dear friend! However, hope you will clarify the doubts mentioned by Albert!

Likes(0)Dislikes(0)

By: Albert van Bemmelen

Albert van Bemmelen — Sat, 05 Oct 2024 11:18:42 +0000

Rather odd that you soldered in another replacement part provided by the customer and added a soldering mask over it without even knowing if the bike control board worked?
And also that you mentioned placing back the ripped off part? That is very confusing to say the least!

Likes(2)Dislikes(1)