Comments on: A Broken SMD Power Switch On A Wireless Microphone Repaired

By: Mendis

Mendis — Thu, 22 Aug 2024 15:25:03 +0000

Great job.thanks for sharing

Likes(0)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Mon, 05 Aug 2024 07:27:57 +0000

In reply to Imoudu.O.

Imoudu: yes we are. gave a blessed day

Likes(0)Dislikes(0)

By: Imoudu.O

Imoudu.O — Sun, 04 Aug 2024 18:35:29 +0000

We are there to re-brand devices to keep on functioning, thanks for sharing.

Likes(1)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Sun, 04 Aug 2024 06:42:47 +0000

In reply to Mark J.

Mark: yes exactly. That was my intentions here. Have a blessed day

Likes(0)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Sun, 04 Aug 2024 06:41:52 +0000

In reply to Albert van Bemmelen.

Albert: read contact would be too big to fit in beside a magnet will not hold on the way it should be. Thanks though for your suggestion. Have a blessed day

Likes(1)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Sun, 04 Aug 2024 06:38:01 +0000

In reply to Yogesh Panchal.

Yogesh: thanks man. The space is very tiny to fit it on board. Have a blessed day

Likes(0)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Sun, 04 Aug 2024 06:36:21 +0000

In reply to Parasuraman S.

Parasuraman: thanks man. Have a blessed day

Likes(0)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Sun, 04 Aug 2024 06:35:27 +0000

In reply to Tayo.

I looked everywhere for it and can not be found. The only way was to send it to the factory to install it back on but that would take time and I am sure expensive so thinking out side the box was my intention. Have a blessed day

Likes(3)Dislikes(0)

By: Mark J

Mark J — Sat, 03 Aug 2024 18:29:49 +0000

Waleed Rishmawi Sometimes you have to think outside the box. Well done.

Likes(0)Dislikes(0)

By: Albert van Bemmelen

Albert van Bemmelen — Sat, 03 Aug 2024 15:44:18 +0000

There maybe also was another way to do this without always needing a toothpick?
Maybe it also was possible to solder a glass reedcontact on the position of the broken off switch. And just by placing a small magnet on top of the reedcontact on the outside of the housing the wireless microphone switches on.

Likes(3)Dislikes(0)