Comments on: A Dead Hovering Board Was Brought Back To Life

By: Yogesh Panchal

Yogesh Panchal — Tue, 27 Oct 2020 12:36:16 +0000

Thanks! waleed for sharing this repair experience.
you always encourage us to get ready to explore new repair challenges.
most of the time technicians denies repair if not familiar with the equipment.

Likes(0)Dislikes(1)

By: Waleed Rishmawi

Waleed Rishmawi — Tue, 27 Oct 2020 07:46:29 +0000

In reply to babums.

Babums: I a glad to hear that. have a blessed day

Likes(0)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Tue, 27 Oct 2020 07:45:49 +0000

In reply to Mark.

Mark: I am not an expert yet on these devices but hopefully someday I will get there...practice maker perfect. have a blessed day.
by the way, my son's name is Mark.

Likes(0)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Tue, 27 Oct 2020 07:44:18 +0000

In reply to Parasuraman S.

Parasuraman: thanks mam. yes but he was not an easy customer to deal with but end up all well. have a blessed day

Likes(0)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Tue, 27 Oct 2020 07:43:15 +0000

In reply to Albert van Bemmelen.

Albert: thanks man. yes, when de soldering, the board has to come off the heat sink otherwise the heat sink will take all the heat and it would be hard to come off. once I did that and added some flux, I was able to more so easily.
have a blessed day

Likes(0)Dislikes(0)

By: babums

babums — Sun, 25 Oct 2020 15:00:35 +0000

This kind of repair added to me a knowledge.Thanks very much for sharing.

Likes(0)Dislikes(0)

By: Mark

Mark — Sun, 25 Oct 2020 04:33:45 +0000

Hey Waleed,
You seem to be the new hoverboard expert!

Likes(0)Dislikes(0)

By: Parasuraman S

Parasuraman S — Sat, 24 Oct 2020 08:51:40 +0000

Well done, my dear friend! Good that luck favoured the user and you got the chance to fix it!

Likes(2)Dislikes(0)

By: Albert van Bemmelen

Albert van Bemmelen — Sat, 24 Oct 2020 06:04:34 +0000

Good job. Removing those thick Mosfets from their solder isn't easy. I know this from a Sedgeway clone motor board that had 13 type irfp90n20 94A 200V
N-channel Enhanced Mosfets that were soldered in very thick solder layers. And because of it almost were impossible to remove and replace. One of the board's controller chips was a Xilinx FPGA chip.

Likes(5)Dislikes(0)