Comments on: A Laminator Machine Repaired. Model: LP330C

By: Reza Ravandi

Reza Ravandi — Tue, 01 Mar 2022 06:49:01 +0000

I think your heat sensor has a problem or it has a gap with the roller.

Likes(0)Dislikes(0)

By: Torach Jimmy

Torach Jimmy — Wed, 17 Nov 2021 20:45:53 +0000

Have tried fixing one laminator here but still failed,it over heats and does not control heat yet the POT is working well

Likes(0)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Sun, 21 Jul 2013 10:57:11 +0000

In reply to shehab kably.

very ture Shehab. it was worth it.

Likes(0)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Sun, 21 Jul 2013 10:56:18 +0000

In reply to Amir Mukhtar.

you are welcome Amir. glad you enjoyed it

Likes(1)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Sun, 21 Jul 2013 10:55:25 +0000

In reply to efren austria.

this diode on the sensor, I could not find it in the stores. I had antoher broken laminator so I took the whole sensor and replaced the old one and it worked nicely.

Likes(0)Dislikes(0)

By: shehab kably

shehab kably — Sun, 21 Jul 2013 07:33:06 +0000

This article shows that no matter how huge the symptoms are it can be caused by
tiny couses. and we should not give up easily.

Likes(0)Dislikes(0)

By: efren austria

efren austria — Sun, 21 Jul 2013 06:51:09 +0000

I have read your article about the laminator machine you repaired.I have also received this kind of machine a week ago with the same problem. I found broken sensor holder and i fixed it but my question is that what is the value of the diode used as a sensor,because when i test it with an ohm meter it gives a high resistance reading that's why i thought this is not an ordinary diode. What kind of diode you used?

Likes(0)Dislikes(0)

By: Amir Mukhtar

Amir Mukhtar — Sat, 20 Jul 2013 20:11:56 +0000

Thanks you Sir Jestine and Mr. waleed for Sharing Valuable Learning Knowledge.

God Bless you

Amir Mukhtar Ashrafi

Likes(1)Dislikes(0)