Comments on: About ADSL Splitter

By: jraju

jraju — Wed, 07 Jul 2021 08:54:06 +0000

Hi, Oh, nice of you for touching inside of the dsl splitter.
But is there a way from checking , if the splitter is working correctly to adsl and phone.
How do we find out without opening as opening involves techniques. Normally there is no screw to be seen outside.
If you say, I will check and then buy a new filter

Likes(0)Dislikes(0)

By: Hameed

Hameed — Wed, 31 May 2017 09:06:02 +0000

The coil value is 330uh..and the capacitor value is 0.0033mfd resistor value is 1ohm...

Likes(0)Dislikes(0)

By: Kushan

Kushan — Sun, 28 Dec 2014 06:16:33 +0000

Replace these two inductors with two 4.4mHen once…surely it will works

Likes(0)Dislikes(0)

By: Jestine Yong

Jestine Yong — Tue, 15 Jan 2013 16:15:18 +0000

In reply to friend.

Sorry I do not have the schematic.

Jestine

Likes(0)Dislikes(0)

By: friend

friend — Tue, 15 Jan 2013 04:27:19 +0000

hello
i see adsl splitter in your web site
i want to get circuit diagram that you show in above
tanks

Likes(0)Dislikes(0)

By: shekar

shekar — Sat, 06 Oct 2012 00:55:54 +0000

I have a nice ADSL spliter UST 0018 can any who has this please send me inside pic of

it.na_shekar@yahoo.com am curious to know the diferance of these.
shekar

Likes(0)Dislikes(0)

By: sally

sally — Fri, 31 Aug 2012 11:57:26 +0000

Hi friend,
About your problem,you can choose a good adsl splitter,also you can use the fiber optic products.

Likes(0)Dislikes(0)

By: Jestine Yong

Jestine Yong — Thu, 19 Jul 2012 00:41:37 +0000

In reply to Boonyarit Tangkakarn.

Hi Boonyarit,

Thanks for the info. My office now using high speed broadband (Fiber optic lines) thus I no longer using the ADSL splitter.

Jestine

Likes(0)Dislikes(0)

By: Boonyarit Tangkakarn

Boonyarit Tangkakarn — Tue, 17 Jul 2012 14:09:13 +0000

I faced the same trouble as you are. I opened the box and found the very similar thing in the box. I bought another one and suspiciously pry out open to ensure that I have the right one. This time, I found a better circuit design. The proper one need to have 2 transformers so that he signal will not interfere with each other. I notice that the coil one will not last and it will eventually cause trouble. It means at the end we have to change to a new one. From now on, when I have to buy this type of ADSL splitter filter, I will be very cautious about the circuitry design.

Likes(0)Dislikes(0)

By: catz

catz — Wed, 25 May 2011 05:15:18 +0000

Try cutting that insulation safely and check whether u can find the disconnected point very closer to the terminals. If so remove the enamal of the remaining coil and solder new wire to it. Then solder that wire to termianl.

Likes(0)Dislikes(0)