Bad Wheels On A Hover Board Replaced
This hover board belongs to my son. He had it for a while and it is time for the wheels to be replaced; I have the right replacement sitting in the shop for a while now.
The first important thing to do is to disconnect the main battery
then proceeded to the taking the four screws off that are holding the sensor board.
All the wires are color coded so it was easy to disconnect and putting them back once the replacement was done.
The sensor board was off revealing the four screws holding the wheels down.
Once this was done the wheels cane off right away.
The replacement wheel is ready to go on board, screwing it back on, and connecting all the color coded cable and test the hover board.
Of course it is the same process for the other side of the hover board when replacing these wheels.
As seen in the photo replacement of the wheels on both sides was done successfully and was waiting for the expert (my son) to come and give it a try and see how it goes.
This article was prepared for you by Waleed Rishmawi, one of our ‘Master Authors’ and currently working in the Bethlehem area of Palestine repairing electrical and electronic equipment.
P.S- Do you know of any your friends who would benefit from this content that you are reading now? If so, forward this website to your friends or you can invite your friends to subscribe to my newsletter for free in this Link.
Note: You can check his previous article on Gate Controller Board With A Nasty Burn Repaired Using Soldering Mask