Comments on: CANON LBP2900 Laser Printer Unit Error

By: Yogesh Panchal

Yogesh Panchal — Tue, 21 May 2024 06:56:17 +0000

Thank You!,Tito Kanshulu

Likes(0)Dislikes(0)

By: Tito Kanshulu

Tito Kanshulu — Sun, 12 May 2024 12:08:52 +0000

Excellent work Sir. Keep it burn

Likes(0)Dislikes(0)

By: Yogesh Panchal

Yogesh Panchal — Sun, 12 May 2024 07:35:38 +0000

Thanks! Waleed

Likes(0)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Sun, 12 May 2024 04:40:41 +0000

I enjoyed your article although I never worked on a printer unless they have power issues. Thanks for sharing and many blessings to you.

Likes(0)Dislikes(0)

By: Albert van Bemmelen

Albert van Bemmelen — Sat, 11 May 2024 12:38:30 +0000

In reply to Yogesh Panchal.

That is a sure thing Yogesh! Also because of the toner powder that is inside these laserprinters that is harmful for eyes, lungs and our health!
The final toner particle is less than 7 µm (microns) in size. Potentially toxic compounds may adhere to the surface of the toner particles, such as volatile organic compounds (VOCs), ethylbenzene, phenols, aldehydes or various carboxylic acids.

Likes(3)Dislikes(0)

By: Yogesh Panchal

Yogesh Panchal — Sat, 11 May 2024 09:43:39 +0000

Albert,
By looking into the Picture it looks difficult task,but trust me it is fun,just remember "Victory is beyond fear" But you have to have knowledge about what you are doing. As far as cleaning is concern Never blow air in side to blow out a dust.there are so many Sensors in side,if few of them accumulate dust at the time of cleaning, printer will behave like mad and it becomes difficult to fault finding.

Likes(2)Dislikes(0)

By: Yogesh Panchal

Yogesh Panchal — Sat, 11 May 2024 09:29:09 +0000

In reply to moshe jacobson.

Thanks!Moshe jacobson.

Likes(0)Dislikes(0)

By: Albert van Bemmelen

Albert van Bemmelen — Sat, 11 May 2024 08:53:37 +0000

You really had a hard job in fixing this laser printer! They are so difficult to service because of the correct disassembly method we have to follow. The many screws and parts we have to disconnect and afterwards have to re-assemble again is no fun for any engineer! Kudos!

Likes(2)Dislikes(0)

By: Yogesh Panchal

Yogesh Panchal — Sat, 11 May 2024 07:55:23 +0000

In reply to Parasuraman S.

Thank you! Sir
I was also being afraid earlier to tackle this type of job But as I tackled them, I gained confidence. it is as opening old radio cassette player mechanism and you will enjoy the work....don't worry go a head & try it. you have nothing to loos,if you done it you will get money & if not,you will get experience.we learned by your articles a lot.

Likes(4)Dislikes(0)

By: moshe jacobson

moshe jacobson — Sat, 11 May 2024 07:22:55 +0000

excellent article!

Likes(1)Dislikes(0)