Comments on: Dead Zen Micro Hifi LCD Component System solved!

By: Parasuraman S

Parasuraman S — Tue, 01 Dec 2015 00:02:38 +0000

In reply to Florin Georgescu.

Oh, my God! You are right! Escaped my attention. Many thanks for this correction!

Likes(0)Dislikes(0)

By: Florin Georgescu

Florin Georgescu — Sun, 29 Nov 2015 02:58:37 +0000

Parasuraman

You keep saying 'zinc'. Zinc is a metal. The correct word is HEAT SINK.

Likes(2)Dislikes(2)

By: Humberto

Humberto — Mon, 16 Nov 2015 18:36:28 +0000

Good repair and a great collection of brushes. Congrats. and keep up.

Likes(0)Dislikes(0)

By: Parasuraman S

Parasuraman S — Thu, 12 Nov 2015 23:58:43 +0000

In reply to Albert van Bemmelen.

Many thanks! Most of the brushes you see are used paint brushes. I have bought a few though, seeings the uses of them. The customer himself has checked the speakers on another amplifier before bringing the amp to me.

Likes(2)Dislikes(0)

By: Paris Azis

Paris Azis — Wed, 11 Nov 2015 18:45:23 +0000

Good job Parasuraman. Thanks for sharing it.

Best Regards

Likes(0)Dislikes(0)

By: Robert Calk

Robert Calk — Wed, 11 Nov 2015 18:34:39 +0000

Good job, Parasuraman. Thanks for the article.

Likes(0)Dislikes(0)

By: Albert van Bemmelen

Albert van Bemmelen — Wed, 11 Nov 2015 14:46:23 +0000

In reply to Suranga Electronics.

Hi Mr.Parasuraman. Well done repair. After replacing both integrated amplifiers, you probably also checked the Customers Loudspeakers from being the cause of the single shorted Amplifier. And cleaning the customers electronic sets on the inside is always the less satisfying part of the repair job. Like you I also occasionally use spirit (also called White spirit or Paint remover) to clean the pcb layout from old solder flux. But I never buy any brushes. I just use one of my old used toothbrushes. Cheers!

Likes(2)Dislikes(0)

By: Suranga Electronics

Suranga Electronics — Wed, 11 Nov 2015 11:17:47 +0000

good repair...

Likes(2)Dislikes(0)