Comments on: Discussion Forum For Anatek’s Products

By: Jestine Yong

Jestine Yong — Fri, 21 Oct 2016 08:03:16 +0000

In reply to Austin.

Hi Austin,

Check the electrolytic capacitor for high ESR value.

Jestine

Likes(0)Dislikes(0)

By: Austin

Austin — Fri, 21 Oct 2016 01:26:58 +0000

Pls i nid help,i am repairing a peavey mark iii series when i insert plug in the input it begins to humm with the control volume please how do i stop the humming

Likes(0)Dislikes(0)

By: admin

admin — Wed, 18 Nov 2009 23:24:05 +0000

HI Jorge,

When I tested aa N channel Fet the component anlayser gave the pinout, leakage currentand voltage. It did not say short circuit. Does this mean that the mosfet is good? or do I have to compare the values form the analyser to the Datasheet?

YES IT IS GOOD

==================

I tested 2 HOT that tested bad with my analog meter and it said short circuit. This means the 2 HOT were not good.

YES, BUT I GUESS THIS METER CAN'T TEST HOT THAT HAVE DAMPER DIODE BUILT IN.

==================

Does this means that if the mosfet was bad, it would say short circuit also?

YES

===================

Jestine

Likes(0)Dislikes(0)

By: jgmanza

jgmanza — Wed, 18 Nov 2009 14:11:49 +0000

Hello Jestine, I got my component analyser from John.

I tested 2 HOT that tested bad with my analog meter and it said short circuit. This means the 2 HOT were not good.

Does this means that if the mosfet was bad, it would say short circuit also?

Thanks
Jorge

Likes(0)Dislikes(0)