Comments on: Electronic Repair Questions/Answers And Testimonials- Part 38

By: admin

admin — Sun, 11 Apr 2010 02:34:51 +0000

HI Yosmer,

Currently i do not have this model in my workshop thus i could not locate the value-sorry.

Jestine

Likes(0)Dislikes(0)

By: Yosmer

Yosmer — Fri, 09 Apr 2010 17:29:49 +0000

Hi Jestine,

I have one monitor dell E173FPb that I bought to repair, but did not bring the IC602 and not the value of that component, do you can tell me the value? I think it is an opto.

excuse my bad English

Grateful
Tovar Yosmer

Likes(0)Dislikes(0)

By: admin

admin — Mon, 07 Sep 2009 15:28:31 +0000

HI Ting,

Check for dry joints at the vertical output ic section. Check also for the supply voltage to the vertical ic and if all tested good then direct replace the vertical output ic and retest it again. Make sure the crt yoke coil connector is connected properly.

Jestine

Likes(0)Dislikes(0)

By: Ting Ban Kang

Ting Ban Kang — Sun, 06 Sep 2009 11:06:39 +0000

Hi Justine,
I am very new(beginer) and knows nothing about electronic, but I love medling with it. Using common sense and a bit of info here and there, at times I managed to repair small electrical items like table fan, hair drier etc..
2. Recently I tried to repair my Toshiba CTV model 29AZ7E which only shows
"white horizontal lines" in the middle. Can you give me some tips?

Likes(0)Dislikes(0)

By: admin

admin — Mon, 31 Aug 2009 13:24:28 +0000

Hi Jie,

Sorry i have not come across this model before thus i could not picture how the connector look like. I guess you might need a gentle way to dismantle any clip (if have) at both side before pulling out the cable.

Jestine

Likes(0)Dislikes(0)

By: Jie Wu

Jie Wu — Wed, 26 Aug 2009 15:09:28 +0000

Hi Jestine,

Glad to find your blog. I am trying to replace my viewsonic(N2635W )LCD controller board ( part number: V260B1-C01 ). Problem is how I can disconnect cable from this controller. The cable is small white color and both side has same pin connector. Thanks

Jie

Likes(0)Dislikes(0)