Comments on: Gecko Got Fried In This Havells Cloth Iron

By: Parasuraman S

Parasuraman S — Tue, 13 Aug 2024 12:27:50 +0000

Yes, you are right! First time is very difficult and it becomes easier as we get exposed to it many times! Thanks for your comments, dear friend!

Likes(0)Dislikes(0)

By: Waleed Rishmawi

Waleed Rishmawi — Tue, 13 Aug 2024 06:20:02 +0000

I used to work on these kind of irones for my mom but they are not being used any more in my home town due to the fact that there are shops in my area who clean, iron clothes and you get them ready in less than one hour or two. I understand the complications in taking these devices apart but once it was done for the first time it gets easier. thanks for sharing and have a blessed day

Likes(1)Dislikes(0)

By: Parasuraman S

Parasuraman S — Sun, 11 Aug 2024 09:23:49 +0000

In reply to Imoudu.O.

If the module has a potentiometer, just adjust it to deliver 12V. If not check all the feedback circuits, especially the resistor values. If any resistor has increased its resistance, this can happen. All the very best!

Likes(3)Dislikes(0)

By: Parasuraman S

Parasuraman S — Sun, 11 Aug 2024 09:21:11 +0000

In reply to Mark J.

There is a gap under the wire connecting part. Many thanks, dear Mark!

Likes(1)Dislikes(0)

By: Parasuraman S

Parasuraman S — Sun, 11 Aug 2024 09:20:10 +0000

In reply to Albert van Bemmelen.

Yah! It is very time consuming and irksome too because of the complexities involved in fixing it back! Many thanks for your expert comments and the link, dear Albert!

Likes(1)Dislikes(0)

By: Parasuraman S

Parasuraman S — Sun, 11 Aug 2024 09:18:50 +0000

In reply to Yogesh Panchal.

Many thanks, dear Yogesh!

Likes(0)Dislikes(0)

By: Imoudu.O

Imoudu.O — Sat, 10 Aug 2024 20:43:03 +0000

l have repaired quit a number of this cloth pressing iron,including laundry iron whish has seperate water tank.The area were one has to be careful when reassembling it, is to put various screws sizes in the right places.Thanks for sharing

Question sir: In the use of tv 3 wires power module install on universal tv board and the minimum voltage out put at secondary diode is 20V instead of 12V, what component should i suspect? help pls.

Likes(2)Dislikes(0)

By: Mark J

Mark J — Sat, 10 Aug 2024 18:59:10 +0000

That is something you do not see everyday. I wonder how the gecko got in to the iron in the first place. Good job on the repair.

Likes(2)Dislikes(0)

By: Albert van Bemmelen

Albert van Bemmelen — Sat, 10 Aug 2024 14:37:47 +0000

Indeed opening and fixing these kind of devices takes a lot of time!
I once preceeded you in such a similar event from years back. Which also took a lot of examining to find and fix the problem in this old repair: https://jestineyong.com/braun-carestyle-3-steamgenerator-iron-repair/

Likes(2)Dislikes(0)

By: Yogesh Panchal

Yogesh Panchal — Sat, 10 Aug 2024 14:31:58 +0000

Good Fix! Sir

Likes(1)Dislikes(0)