Comments on: How To Repair Wax Heater- No Power

By: Yogesh Panchal

Yogesh Panchal — Fri, 15 Jul 2016 07:20:44 +0000

In reply to ravi.

Ravi,

Thanks for comment.

Likes(0)Dislikes(0)

By: Yogesh Panchal

Yogesh Panchal — Fri, 15 Jul 2016 07:05:34 +0000

In reply to Rudy Formigoni.

Rudy,

Feel proud to get the comment from these geniuses.

Let me Congratulate! you for not making a single mistake in your entire technical life .

I think these platform is provided for sharing success story as well mistake done while on job . i have shared my experience for new comers who can at-least skip the mistake and handle the job carefully.

any way thanks for sharing your views.

Likes(1)Dislikes(0)

By: Yogesh Panchal

Yogesh Panchal — Fri, 15 Jul 2016 06:50:52 +0000

In reply to suranga bandara, Suranga Electronics.

Thanks Suranga.

Likes(0)Dislikes(1)

By: Yogesh Panchal

Yogesh Panchal — Fri, 15 Jul 2016 06:50:04 +0000

In reply to Parasuraman S.

sir,

Thanks for your comment.

Likes(0)Dislikes(0)

By: Yogesh Panchal

Yogesh Panchal — Fri, 15 Jul 2016 06:49:20 +0000

In reply to Gerald.

Gerald,

thanks for info.

Likes(0)Dislikes(1)

By: Yogesh Panchal

Yogesh Panchal — Fri, 15 Jul 2016 06:48:25 +0000

In reply to Albert van Bemmelen.

Albert,

Thanks for the comment.

Likes(1)Dislikes(1)

By: Yogesh Panchal

Yogesh Panchal — Fri, 15 Jul 2016 06:47:07 +0000

In reply to Humberto.

Humberto,

Thanks for your comment.

Likes(0)Dislikes(2)

By: Rudy Formigoni

Rudy Formigoni — Thu, 14 Jul 2016 21:15:53 +0000

Ok Peter,
I only referred to the apprenticeship as a means of explaining how long we are trained for in this field.I'm no young pup in the field,i've been an electrical contractor for 45years,i'm only trying to get the message across to these guys who obviously don't know what they are doing when it comes to mains electricity,to not play with it as you only have to make one mistake & the result could be fatal.I only wish after reading some of these articles that someone else would come forward instead of sitting back & give a bit of support to my "lecture" for the sake of electrical safety in the field no matter whether you are qualified or not.Mr Jestine Yong should have a bit of input here as this was originally his site for information on electronic repair of various equipment & training of students.

Likes(0)Dislikes(0)

By: Albert van Bemmelen

Albert van Bemmelen — Thu, 14 Jul 2016 10:14:34 +0000

In reply to Anthony Paterson.

Naturally the Author didn't intend to connect it to Earth connection either. But since he took the picture from the internetpage he found, he didn't make any mistake himself while connecting the Wax Heater he repaired.
And since there are three increasingly accurate estimates of zero voltage references: Earth ground for a power system, chassis ground for a device, and signal ground for the very low voltage signals within a device, the Earth symbol is often used misplaced in a schematic.
See: https://www.quora.com/What-is-the-difference-between-chassis-ground-signal-ground-and-earth-ground

Likes(2)Dislikes(0)

By: Peter Owens

Peter Owens — Thu, 14 Jul 2016 03:09:37 +0000

Switches, particularly rockers are often a bit confusing.
I usually carefully check the mode of operation if I have any cause to suspect integrity.
We all make mistakes, amateurs, & electricians & we do not need a Holyier than thou lecture from a young pup not long out of his apprenticeship.

Likes(2)Dislikes(0)