Comments on: Investigating In-& Outdoor DVB-T2 Antennas

By: Albert van Bemmelen

Albert van Bemmelen — Sat, 20 Aug 2022 16:41:15 +0000

Yes, they sell others too like stereomicroscopes like my shopowner was very happy with. But I am quite happy with my new firmware fixed G600 LCD microscope and my older Traveler USB microscope.

Likes(0)Dislikes(0)

By: Yogesh Panchal

Yogesh Panchal — Fri, 19 Aug 2022 10:39:56 +0000

Good JOB! Albert,
Now a days HD Microscope cameras available which can be connected to BIG Screen TV with HDMI / VGA port.

Likes(0)Dislikes(0)

By: Ahmet

Ahmet — Fri, 19 Aug 2022 02:17:18 +0000

In reply to Ahmet.

Location in Malaysia

Likes(0)Dislikes(0)

By: Ahmet

Ahmet — Fri, 19 Aug 2022 02:16:33 +0000

Hi, I am looking for someone who can repair my faulty Gimbal for smartphone

Likes(0)Dislikes(0)

By: Albert van Bemmelen

Albert van Bemmelen — Wed, 17 Aug 2022 14:04:10 +0000

In reply to Anwar Shiekh.

Yes true, but the articles were made in one go as they happened. And are as you could see related. I even could have made 3 different repairs. One about the G600 LCD Microscope, one about the outside antennas, and one about the inside Taffware repair. But they all did fit in one.

Likes(0)Dislikes(0)

By: Albert van Bemmelen

Albert van Bemmelen — Wed, 17 Aug 2022 13:55:45 +0000

In reply to Mikael Hansen.

You could try if those work although polarization will be different. Probably now Vertical instead of horizontal. I tried the two I had but they just didn't work at all. Plus my amplified outside antennes have extra 4G/LTE filters in them.

Likes(0)Dislikes(0)

By: Mikael Hansen

Mikael Hansen — Tue, 16 Aug 2022 22:55:36 +0000

Why not stay with the old fashioned passive TV antennas?
No build in amplifiers that need power supply.
And DVB-T (and T2) uses the same frequencies as analogue TV did, so there is no need for a new type of antenna.

Likes(0)Dislikes(0)

By: Anwar Shiekh

Anwar Shiekh — Sun, 14 Aug 2022 16:45:05 +0000

Would have been nice to have separated the two repairs as separate articles

Likes(0)Dislikes(0)

By: Albert van Bemmelen

Albert van Bemmelen — Sun, 14 Aug 2022 07:23:29 +0000

It's a bit like ...one for the money, two for the show
Three to get ready, now go, cat, go. (I hope I won't get sued for stealing someones music now... lol)

Likes(0)Dislikes(0)

By: Albert van Bemmelen

Albert van Bemmelen — Sat, 13 Aug 2022 16:39:50 +0000

In reply to AdamS.

You are right. And if I hadn't found that perfect firmware upgrade I never would have enjoyed using my G600 LCD microscope. And I would have ended up with a cheaper but useless product. Still good products are also made in China like the RT809H that I needed to reflash my G600 eeprom with. My GQ4x4, my G540, my Xeltek SP-L, my TL866I & II, they all couldn't read and write to the for them unknown algoritm eeprom chip. And only the GQ4x4 is also capable in only writing to parts of most (e)eproms. Because the other universal programmers are incapable in writing to only a specific part in their memory. Which I am almost sure also the RT809H is capable of but haven't tested yet. Which I noticed when I wanted to write into just a specific part of an 27512 eprom memory with the firmware content of a 27256 eprom for my fixed Commodore 1571 floppydrive.

Likes(0)Dislikes(0)