October 19, 2011 at 10:20 pm
I totally agree with being carefull when soldering. sometimes extra heat is used and the battaries are either will go bad or explode..that could be very dangerous. the tip of the battary from both sides are soft and something the solder does not stick to them the way it should be. so to make it extra strong. I used a sharp knide and cut tiny small lines on the both tips of the battaries then add solder to them. from experience, I found that method very effective in adding more strength to the soldering.
October 21, 2011 at 4:36 am
How are you.
The knowledge of battery rebuilding is marvelous and catchy.
But, Precautions need to be followed in order to work done successfully. however, mostly batteries having plastic PCB circuitry inside the battery which handle hard sometimes. therefore, its always upto to the worker how they handle safely and take results upto the requirements.
Well done for providing guidance.
Your email address will not be published. Required fields are marked *
Save my name, email, and website in this browser for the next time I comment.
This site uses Akismet to reduce spam. Learn how your comment data is processed.
If you are repairing many same model of mainboard, there...
This Philip Plasma tv was brought to my home for...
Just completed today the 6 days Basic and Advanced Electronics...
I often got technical questions from my training students and...
My replacement gas heating...
Just completed today the Higher Advanced Electronics Repair course (level...
Copyright © 2021 JestineYong.com