Don't Miss

Low Heat In Rice Cooker Repaired

By on July 13, 2021
rice cooker repair

how to fix rice cooker

The complaint of this Richsonic rice cooker was low heat even though you have  pressed the cook button/switch. Usually it will gets hot and start to cook rice but somehow this rice cooker was not able to produce the kind of heat needed.

I felt the low heat by placing my hand just few inches above the heating element as seen from the photo below:

low heat in rice cooker repair

I opened the bottom cover of the rice cooker to expose the internal circuit/wiring.

how to repair rice cooker

Once the cover was opened I could immediately saw a burnt wire and I have checked all other parts and they were all good.

I believe the burnt wire is the only cause of the problem of low heat. Take a look at the photo below:

servicing rice cooker

I fabricated my own new wire and fixed it back to the same location where I took the bad wire out.

I powered on the rice cooker and tested the heat again and all was back to normal. See the three photos below:

hot melting withstand wire

how to fix a wire

how to fix and repair rice cooker

Conclusion- Rice cooker is a simple and fast way to cook rice but not all household owns one. After reading the above article and this rice cooker article, I believe you will be able to repair rice cooker if yours have a fault.

suranga

This article was prepared for you by Suranga Bandara who owns an Electronics repair shop in Anuradapura, Sri Lanka.

Please give a support by clicking on the social buttons below. Your feedback on the post is welcome. Please leave it in the comments. If you have electronic repair articles to share with us, please contact us HERE.

P.S-  If you enjoyed reading the above article, click here to subscribe to my blog (free subscription). That way, you’ll never miss a post. You can also forward this website link to your friends and colleagues-thanks!

Note: You may check out his previous post about No Signal In Konka LED TV

Likes(60)Dislikes(0)

7 Comments

  1. Mike Blake

    July 13, 2021 at 12:11 pm

    It seems to be a common fault in stoves cookers etc where the wire is crimped, I tend to believe the actual crimped connection point becomes a little high resistance and the resultant heating becomes exponential destroying the joint.

    Likes(4)Dislikes(0)
  2. Gassan Ali

    July 13, 2021 at 1:06 pm

    Nice work

    Likes(1)Dislikes(0)
  3. Parasuraman Subramanian

    July 13, 2021 at 3:43 pm

    Good professional fix!

    Likes(0)Dislikes(0)
  4. Yogesh Panchal

    July 13, 2021 at 6:22 pm

    Good job !Suranga

    Likes(0)Dislikes(0)
  5. Albert van Bemmelen

    July 13, 2021 at 7:00 pm

    It was good that you also used a good 230VAC wire that is heat resistant from looking at the outside insulation.

    Likes(1)Dislikes(0)
  6. Humberto

    July 13, 2021 at 9:44 pm

    Great repair Suranga

    Likes(0)Dislikes(0)
  7. denish

    August 25, 2021 at 1:30 am

    great work

    Likes(0)Dislikes(0)

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Open

Close