Comments on: Makita Hammer Drill Phase Repaired

By: sudarshan

sudarshan — Sat, 15 Nov 2014 18:38:33 +0000

In reply to Corriete.

I would have thought that the variable resister in the switch would be worn out or shorting. Assuming that the switch has variable resister in it when pressed.

I am just guessing this, but hope that you will get some answers from some where and repair your drill.

Likes(0)Dislikes(0)

By: Joshua Oloo

Joshua Oloo — Wed, 12 Nov 2014 12:38:16 +0000

Good job and keep it up!!

Likes(0)Dislikes(0)

By: Henrry Were

Henrry Were — Wed, 12 Nov 2014 08:10:50 +0000

In reply to Robert.

pat on the back good job

Likes(0)Dislikes(0)

By: Robert

Robert — Wed, 12 Nov 2014 02:49:19 +0000

Good job Mark. Thanks for sharing the repair with us.

Likes(0)Dislikes(0)

By: Abdul

Abdul — Wed, 12 Nov 2014 00:57:13 +0000

Good work.
Have a nice day.
Abdul (Singapore)

Likes(1)Dislikes(0)

By: Humberto

Humberto — Tue, 11 Nov 2014 13:06:48 +0000

Good job, keep up

Likes(0)Dislikes(0)

By: biruk aweke

biruk aweke — Tue, 11 Nov 2014 04:46:49 +0000

Good repair have a nice day.

Likes(0)Dislikes(0)

By: Andre Gopee

Andre Gopee — Mon, 10 Nov 2014 21:46:31 +0000

Good Work Mark and keep it up.

Likes(0)Dislikes(0)

By: Corriete

Corriete — Mon, 10 Nov 2014 20:49:47 +0000

great to know this could be saved from the dump .congratuations. i have a drill with a capacitor number AC175 SH40/100/56 and it spins faster than usual. can anyone share if the cap is the cause of the faster than usual spin of the rotor OR Something else? thanks

Likes(0)Dislikes(0)