No Power In Daytron Iron Repaired
The Daytron Iron came in for repair with the complaint of no power. Even the big center temperature control knob had been adjustable there was still no power light. Common fault of a faulty iron are usually due to broken cable, bad thermostat and open thermal fuse.
More serious case would be an open heating element. The first I did was to open up the casing and check for any broken cable with my meter’s continuity tester-see the two photos below:
The continuity test found both the live and neutral wire were good and my next test was the thermal fuse which was covered by the fiberglass heat resistant sleeve (white color sleeve)-see the photo below:
The thermal fuse was checked to be opened circuit and my next test was to check on the thermostat.
If you look at the photo below, you will see the meter reads 000 which means the contact is good.
After the replacement of the thermal fuse (10 amp 250 volt) I turned On the Iron and the power light immediately lighted up-see the photo below:
Conclusion- Repairing Iron is pretty straight forward. If there are few Irons that come across your repair bench, it would not take long for you to become expert in repairing Iron. All the best
This article was prepared for you by Suranga Bandara who owns an Electronics repair shop in Anuradapura, Sri Lanka.
Please give a support by clicking on the social buttons below. Your feedback on the post is welcome. Please leave it in the comments. If you have electronic repair articles to share with us, please contact us HERE.
P.S- If you enjoyed reading the above article, click here to subscribe to my blog (free subscription). That way, you’ll never miss a post. You can also forward this website link to your friends and colleagues-thanks!
Note: You may check out his previous post in the below links: