Comments on: Prediction Of An Expert In This Forum Came True In SAMSUNG LED TV UA32FH4003R

By: Parasuraman S

Parasuraman S — Fri, 05 Jun 2026 13:58:20 +0000

There was no replacement of the LED strip last time. Only fallen domes were fixed back. Many thanks for your comments!

Likes(0)Dislikes(0)

By: Tito Kanshulu

Tito Kanshulu — Fri, 05 Jun 2026 11:54:01 +0000

Could it be that the LED strips you replaced earlier dd not match the required voltage or there was over usage of the tv by the owner? Sometimes it is demoralizing to see the same tv coming for repair again and again. Thanks for article Parasuraman

Likes(1)Dislikes(0)

By: Parasuraman S

Parasuraman S — Sun, 31 May 2026 01:53:43 +0000

In reply to Imoudu.O.

When the domes fall off, it is an indication that the back light LEDs have reached the last stage of its life. But that time, replacement of the LEDs was not done due to budget constraints. This time, the customer was forced to spend and that it why it was done now. But the TV worked in that condition for a few months and that is a solace. Many thanks for your involved comments and queries, dear Imoudu! Special greetings and love from India!

Likes(0)Dislikes(0)

By: Imoudu.O

Imoudu.O — Sat, 30 May 2026 16:44:48 +0000

In reply to Parasuraman S.

I wonder why the tv came back for a backlight replacement again barely 8 months after it was first replaced,why the led strips did last long, or could it be tv is heavily being use by owner?
Good repair again sir.

Likes(1)Dislikes(0)

By: Parasuraman S

Parasuraman S — Sat, 30 May 2026 11:52:37 +0000

In reply to Albert van Bemmelen.

Yes, you definitely have the freedom of choice and decide what to take and what not to take. Many thanks, dear Albert!

Likes(0)Dislikes(0)

By: Parasuraman S

Parasuraman S — Sat, 30 May 2026 00:49:36 +0000

In reply to Mark J.

Many thanks, dear Mark!

Likes(0)Dislikes(0)

By: Albert van Bemmelen

Albert van Bemmelen — Fri, 29 May 2026 22:54:59 +0000

In reply to Parasuraman S.

Yes, fully understood dear Parasuraman. Of course I know what we are supposed to do but I still rather take on any other much smaller repair.
Repairs that do not involve these large breakable glass plates with questional liquids in them and similar risky stuff.

Likes(1)Dislikes(0)

By: Mark J

Mark J — Fri, 29 May 2026 18:44:02 +0000

Parasuraman great job once again. Your TV repair articles are always informative.

Likes(1)Dislikes(0)

By: Parasuraman S

Parasuraman S — Fri, 29 May 2026 13:01:40 +0000

In reply to Albert van Bemmelen.

It was just for some fun, that's all, dear Albert! Any article with a catchy caption would attract readers and that was the intention. No offence meant!

About your 50" TV, I request you not to worry. Take a large size lamination sheet which will not bend or similar strong but smooth material, after releasing the panel from all sides. Then keep the scaler board and COF stuck on the front side with a few tapes so that they do not get torn. Then gently insert the sheet horizontally or vertically until it reaches all sides of the panel. Then use spongy gloves and gently lift it putting your palm and fingers underneath to the center of the panel for balancing, while holding the bottom edge portion with the other hand. If possible take help from your brother to hold one side but with soft gloves. Never apply downward pressure on the panel at any place. Then move it to any vacant bed. Do the rest of the work and reverse the process. I have explained all these in my previous articles. Kindly refer to them. Or watch any youtube video. All the best.

Likes(1)Dislikes(0)

By: Albert van Bemmelen

Albert van Bemmelen — Fri, 29 May 2026 09:47:56 +0000

Sorry to hear that this tv came back for another timeconsuming repair dear Parasuraman. But I would not so much as confirm that I made a prediction on this tv. As you know I am no tv expert. And from experience we already have seen other tv models revisiting for additional repair work in the past too.
It is just that I made a remark that fixing backlight led strips should have been made so much easier!
My brother's 50 inch LG tv with now at least 10 fallen off led diffuser light caps needs a repair soon too to fix all those visible bright sunny spots. But removing the top 50 inch large panel without breaking or polluting the lcd panel or its diffuser plates is a big and risky task. And gluing all caps back on including those that have not fallen off yet is something I am not really confident about either. Last year I already bought UV hardening transparant glue and an expensive big silicon sucking frame to lift the glass lcd panel safely but have never used it before either. And it also requires a large clean table and the right time and weather to disassemble such a large tv.

Likes(2)Dislikes(0)