Professional Clipper Went Back to Life
This Professional Clipper was brought to me due to it was fully dead. It was brand DAYTRON and Model DAYT – B025
First thing done was to disarm the equipment.
As you can see in the photos above, this machine uses a simple vibrator system to move the blades which cut the hair. The resistance of the vibrator coil was tested on with a Digital Multimeter and it was ok: nor shorted neither open.
The other step was to check on the ON/OFF switch and guess what? It was not working, the better solution would have been to change it, but by misfortune I had not any similar. So the duty was more complicated, why? Because I decided to mend it, see the photos below.
So it was disarmed completely.
The switch was fully mended and when it was checked on with the Digital Multimeter the result was satisfactory.
The clipper was connected into the wall outlet and it worked, but not correctly because you had to move the cable for the machine to work, there was a broken cable.
So the cable was cut outside the machine and re-soldered again with the new section. This time the machine really worked fine.
This time the clipper was fully repaired and saved from the dump.
This article was prepared for you by Humberto Rodriguez, one of our ‘Master Authors’ from Cuba.
Please give a support by clicking on the social buttons below. Your feedback on the post is welcome. Please leave it in the comments.
P.S- If you enjoyed reading this, click here to subscribe to my blog (free subscription). That way, you’ll never miss a post. You can also forward this website link to your friends and colleagues-thanks!
Note: You may check his previous repair article in the below link: