Don't Miss


Replacing A Charging Port On A Bluetooth Speaker Board.

By on November 10, 2020
Replacing A Charging Port On A Bluetooth Speaker Board.

 

 

 

 

 

 

 

 

 

 

A technician and also a friend of mine brought this device for port replacement. This technician did not have the charging port for replacement so he sends it to me to do that job.

blue tooth speaker repair

He already took the board out and from what I saw; the area of that charging port was a big mess.

bluetooth speaker fix

As you can see, it was covered with epoxy and it had to be removed and cleaned.

And if you look the soldering job done there, it is even worse than the epoxy itself.

charging port connector replaced

Here I have a variety of charging ports that fits almost all phone except iphone of course.

how to replace micro connector

I have taken the old charging port off board, cleaned the area, found the right replacement and then tested the board.

charging connector fixed

The middle three pins were not connected to anything so the only pins that needed to be soldered to the board was the ground and the hot which was very easy to do.

charging connector repaired

And as it is seen in the photo, the charging LED light came on which is an indication that all went well.

Mission Accomplished.

This article was prepared for you by Waleed Rishmawi, one of our ‘Master Authors’ and currently working in the Bethlehem area of Palestine repairing electrical and electronic equipment.




P.S- Do you know of any your friends who would benefit from this content that you are reading now? If so, forward this website to your friends or you can invite your friends to subscribe to my newsletter for free in this Link.

Note: You can check his previous repair articles in the link below:

https://jestineyong.com/a-laptop-working-fine-but-had-audio-problems-model-asus-x556u/

 

Likes(50)Dislikes(1)

5 Comments

  1. Albert van Bemmelen

    November 10, 2020 at 8:59 pm

    As a professional repair engineer you also have a good sense of the things that are required to have in stock for cases like these. Recently I also ordered a set of several of those MicroUSB connectors. They are frequently needed. Not only for repair but also for building new electronic projects.

    Likes(1)Dislikes(0)
    • Waleed Rishmawi

      November 11, 2020 at 2:42 pm

      Albert: indeed and I am in the processing of ordering more to be sold for technicians and for repair parts in the shop. it is the way to go otherwise, I am sitting in the shop waiting for parts and customers do not want that kind of wait. have a blessed day

      Likes(1)Dislikes(0)
  2. Parasuraman S

    November 10, 2020 at 9:42 pm

    I am amazed to see your collections! Shows your concern and commitment! Well done!

    Likes(1)Dislikes(0)
    • Waleed Rishmawi

      November 11, 2020 at 2:43 pm

      Parasuraman: thanks man. I am ordering more stuff for the shop for the repair and also parts to be sold to other technicians if they need them for repair. have a blessed day my friend

      Likes(0)Dislikes(0)
  3. Yogesh Panchal

    November 13, 2020 at 11:07 pm

    waleed,
    Now a days customers are not ready to wait for the part if they have more options of technicians. if want to survive in this industry and having exclusive repair shop it is better to keep some running parts handy.

    Likes(0)Dislikes(0)

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Free Report