Don't Miss


Setting Up Electronic Repair Workbench

By on March 16, 2010

 workbench

If you have the budget you can always buy a new repair workbench that have all the things done for you like the AC points, place to put components, test equipment and etc. However, if you are on tight budget, you can always convert a normal/used desk/table into a workbench. Search from the internet for the photos of those professional workbench and you will definitely get some ideas about it. Assuming you are converting the desk/table into a workbench what you need to do is to first find a place to secure the AC plug whether to place it right or left side depending whether you are right or left handed. Then, locate the place to put in your tools, meters, technical books, schematic diagrams and etc.

For your information, there is no perfect workbench because it all depends on your preference on how you set it up. Once you have done setting up the workbench, you then start to do the repair job and from there you can adjust the place accordingly to suit your convenience.

Likes(2)Dislikes(0)

5 Comments

  1. Mike

    January 23, 2014 at 4:01 am

    Hello Justine. I was searching for a workbench for my new electronics repair business and came across your page. You have a very helpful advise and I would like to know where to get a bench like you show in the picture above your article. Your response will be greatly appreciated. Thank you Mike

    Likes(1)Dislikes(0)
    • Jestine Yong

      January 23, 2014 at 1:43 pm

      Hi Mike,

      My workbench is not as sophisticated as the one in the picture shown. You can visit the link below to pick the one you like:

      https://www.google.com/search?q=electronics+workbench&tbm=shop&source=lnms&sa=X&ei=3KDgUolczpesB_DSgOgI&ved=0CAkQ_AUoAQ&biw=1024&bih=629&dpr=1

      Jestine

      Likes(2)Dislikes(0)
  2. Mike

    January 24, 2014 at 3:49 am

    Thank you. The link is very helpful. Do you know where to get the bench in the picture?

    Likes(1)Dislikes(0)
    • Jestine Yong

      January 24, 2014 at 9:31 pm

      Hi Mike,

      Sorry I forgot already. The article was posted many years ago.

      Jestine

      Likes(0)Dislikes(0)
  3. Jason

    April 10, 2015 at 3:51 pm

    Hello,Mike & Jestine Yong:
    I know where can purchase the workbench in the picture.
    I am PCB manufacture, i just purchased some workbench same like the picture.
    So if Mike want to know. You can email me. Email:jasonhcl1993@gmail.com
    I can give you my supplier.
    Thanks and best regards,
    Jason Huang

    Likes(2)Dislikes(0)

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Free Report