Comments on: Shorted Degaussing Coil https://jestineyong.com/shorted-degaussing-coil/ Semiconductors, Test Equipments, Circuit Board Troubleshooting, Electronic Repair Courses and Many More! Mon, 22 Jan 2018 02:11:00 +0000 hourly 1 https://wordpress.org/?v=5.4.19 By: Jestine Yong https://jestineyong.com/shorted-degaussing-coil/comment-page-1/#comment-328504 Mon, 22 Jan 2018 02:11:00 +0000 https://www.jestineyong.com/?p=2045#comment-328504 In reply to Stewart.

Hi Stewart,
Have you tried closing it using black tape?

Jestine

Likes(0)Dislikes(0)
]]> By: Stewart https://jestineyong.com/shorted-degaussing-coil/comment-page-1/#comment-328399 Fri, 19 Jan 2018 02:49:17 +0000 https://www.jestineyong.com/?p=2045#comment-328399 In reply to Stewart.

Is possible to fix the split with electrical tape or something similar? does the coil have larger problem there.

Likes(0)Dislikes(0)
]]> By: Stewart https://jestineyong.com/shorted-degaussing-coil/comment-page-1/#comment-328398 Fri, 19 Jan 2018 02:47:50 +0000 https://www.jestineyong.com/?p=2045#comment-328398 Hi Jestine,
I have what looks like a small split opening in the black tape. When the degauss coil runs it has problems getting that corner, gets extremely close to being perfect while running for the 5s, but the end when it shuts off, it spikes that corner and leaves a large magnet spot. I can wipe it clean with a separate deguasser or wiping a magnet on the tube shielding panel there works very well, gets it perfect and stays like that until degauss runs.
-Stewart

Likes(0)Dislikes(0)
]]> By: raymundo.saura@yahoo.com https://jestineyong.com/shorted-degaussing-coil/comment-page-1/#comment-195863 Sun, 29 Sep 2013 02:29:08 +0000 https://www.jestineyong.com/?p=2045#comment-195863 thanks for this article another good one for me thanks and GOD bless

Likes(0)Dislikes(0)
]]> By: admin https://jestineyong.com/shorted-degaussing-coil/comment-page-1/#comment-36471 Fri, 11 Nov 2011 05:40:32 +0000 https://www.jestineyong.com/?p=2045#comment-36471 HI Austin,

If the power supply have Varistor then it can tripped. Fet casing shorted to hot ground also could trip.

Jestine

Likes(0)Dislikes(0)
]]> By: austin https://jestineyong.com/shorted-degaussing-coil/comment-page-1/#comment-36346 Thu, 10 Nov 2011 20:09:37 +0000 https://www.jestineyong.com/?p=2045#comment-36346 Hi Jestine,

Beside degaussing coil, what others component in a monitor causes ELCB to trip when we apply AC power?

I have a monitor causes the ELCB to trip. Found a FET and 2 resistors faulty near the primary side of the SMPS transformer.

Austin.

Likes(0)Dislikes(0)
]]>