Comments on: VCR EATS TAPES. THE MOST COMMON CAUSE -Part 2 https://jestineyong.com/vcr-eats-tapes-the-most-common-cause-part-2/ Semiconductors, Test Equipments, Circuit Board Troubleshooting, Electronic Repair Courses and Many More! Wed, 29 Apr 2020 10:12:25 +0000 hourly 1 https://wordpress.org/?v=5.4.19 By: Jestine Yong https://jestineyong.com/vcr-eats-tapes-the-most-common-cause-part-2/comment-page-1/#comment-368398 Wed, 29 Apr 2020 10:12:25 +0000 https://www.jestineyong.com/?p=11855#comment-368398 In reply to Nasim.

Hi Nasim,

If your problem is auto eject perhaps check on the youtube link here to get some ideas.

Jestine

Likes(0)Dislikes(0)
]]> By: Nasim https://jestineyong.com/vcr-eats-tapes-the-most-common-cause-part-2/comment-page-1/#comment-368345 Sat, 25 Apr 2020 16:39:18 +0000 https://www.jestineyong.com/?p=11855#comment-368345 Hi Jestine
I have sharp vcr midel vc 790 ET multi system I t was using it to transfer pal vhs tapes to dvds.
Now when I insert the tape it go down stay there few seconds and come back it does like this few times and than stops. Also the head id not turning ON too.
I think it is not detecting the the tape. I opened the tape carrier and checked all the micro switches are fine. There is small cct board in the bottom where the Tape sits and run i think this is for to detect the tape and also i checked the sensor embedded inthe small plastic stand which is also used to unlock spools. Sensor shows resistance. I also tried different tapes but still the problem is there. Would you please like me to suggest some thing help me to solve my problem.

Nasim

Likes(0)Dislikes(0)
]]>