Don't Miss


What Is Ground Loop Isolator?

By on April 18, 2010

If you need more information about what is Ground Loop Isolator then please on the photo to visit the website for full details explanation:

 groundloopisolator

groundloopisolatorcircuit

Likes(7)Dislikes(0)

9 Comments

  1. mohdnaazri

    April 18, 2010 at 7:58 am

    Hi Mr Jestine.

    I have control board for LED display. It always use at highway , How to contact your to show the board either it can be repair or not.

    I stay in KL

    Likes(0)Dislikes(0)
  2. Waleed

    April 19, 2010 at 2:23 am

    thanks for the article..I have seen these things so many times but had no idea what they are. now, I know

    Likes(0)Dislikes(0)
  3. admin

    April 19, 2010 at 4:26 am

    HI Mohd,

    You can call my office at 603-62778522. By the way, how do you know of my company?

    Jestine

    Likes(0)Dislikes(0)
  4. yao

    January 22, 2011 at 5:55 am

    where to find this?

    Likes(0)Dislikes(0)
  5. admin

    January 23, 2011 at 10:38 am

    HI Yao,

    Just type in google "buy ground loop isolator" and there will be lots of sites selling this device.

    Jestine

    Likes(0)Dislikes(0)
  6. John Aldrich

    January 30, 2012 at 10:50 am

    Hi, I need your help. I have a humming problem in my turntable setup. Whenever I turn up the volume or tap on the turntable, a loud humming noise can be heard on the speakers. I have already grounded my TT to my amp.

    I am wondering if a "Ground Loop Isolator" would solve my problem.

    Thanks.

    Likes(0)Dislikes(0)
    • Fred

      December 17, 2013 at 6:54 am

      A hum made by a turntable shouldn't come and go with tapping,sounds like a wire opening,I would take the wires lose on both ends and check them one at a time with a ohms meter (set meter on ohms R X 1 and attach each cable end to one meter probe,this should read 000 on the meter Then move the wire around,wires break where they move the most. the meter reading should not change if it does that wire is bad replace it),if that passes ok,try the cartridge I would google it to see how it's made and see how to test it ,One other thought,is to check how tight and how clean your connections are use alcohol to clean them check the plugs too for bad solder joints,
      Good luck!
      Fred

      Likes(1)Dislikes(0)
      • Jestine Yong

        December 17, 2013 at 10:24 am

        Hi Fred,

        Thanks for the input!

        Jestine

        Likes(0)Dislikes(0)
  7. admin

    January 30, 2012 at 8:02 pm

    HI John,

    Before you get the above device, i suggest that you check all the e-caps in the set because an open e-cap also could cause humming sound.

    Jestine

    Likes(0)Dislikes(0)

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Free Report