Don't Miss
  • About The Workshop

    Yesterday, after the  workshop about 5.00pm i went home and brought along my family and gather at my friend house for BBQ and i reached home about midnight. Okay the workshop that i had attended yesterday was...

    • Posted May 24, 2009
    • 4
  • Attending A Seminar Tomorrow

    I will be attending a seminar/workshop tomorrow (from 9am to 5pm) and after that i will be going to a friend house for a gathering (having BBQ). I will let you know what topic of the seminar...

    • Posted May 22, 2009
    • 0
  • Open Circuit In Heater (Filament) Of CRT Tube

    After so many CRT Monitors sent in for repair, i could say that i only came across one unit of a 14″ Acer Monitor that had an open winding in the filament (heater). The complaint was no...

    • Posted May 21, 2009
    • 91
  • Doubt About Using ESR Meter

    If you have been using the normal analog and digital capacitance meter to check electrolytic capacitor, then suddenly switch to ESR meter, i’m sure you may have doubt about the accuracy of the meter to find bad...

    • Posted May 20, 2009
    • 4
  • Open Winding In Yoke Coils

    Well, I’m not sure about you and as for me so far after so many years in this repair line i had only came across only few PC tube that have open winding in yoke coils. It...

    • Posted May 19, 2009
    • 9
  • About USB Oscilloscope

    I have not use this type of scope before. If you have this type of scope i wish that you could share out your experience with us-thanks in advance. Please click on the picture to view the...

    • Posted May 18, 2009
    • 0
  • Finding Good Test Points

    Whatever electronic equipment that you are repairing one must know where are the good test points located. You can’t just simply use a voltmeter or Oscilloscope to poke around the board. You must know what you are...

    • Posted May 17, 2009
    • 0
  • Compilation Of Electronic Repairing Websites

      Here’s a good website that contains lots of electronic troubleshooting and repairing information. Please click on the picture to visit the website   Likes(0)Dislikes(0)

    • Posted May 17, 2009
    • 0