Don't Miss
Bought Small Drill Bit And A Motor
By Jestine Yong on December 13, 2008
If you would like to make your own PCB and do not know how to make hole on it then i guess you need to get a drill and a motor to do the job. Today I bought two small drill bit and a motor powered by a 9 volt battery. It has the connector to secure the drill bit together with the motor shaft. I have tested the set and it was very easy to drill small hole on any pcb board. Below are the photos of how these components look like:
Likes
(1)Dislikes
(0)
![](https://jestineyong.com/wp-content/plugins/like-dislike-counter-for-posts-pages-and-comments/images/up.png)
![](https://jestineyong.com/wp-content/plugins/like-dislike-counter-for-posts-pages-and-comments/images/down.png)
![](https://jestineyong.com/wp-content/uploads/2021/07/electronics-repair-journey.jpg)
DRILL BITS
December 2, 2010 at 12:57 pm
This is looks so nice..There are lot many makers of drill bits sets offering quality material and durable and sturdy drill bits. Thanks so much......