Don't Miss

PCB Etching, Dying and Tinning

By on May 11, 2011

This video was recommended by Mr Grant and it has relation to the May repair newsletter on How To Make Your Own PCB Circuit.

Likes(0)Dislikes(0)

4 Comments

  1. Daud Asi

    May 11, 2011 at 10:01 pm

    such type of videos are very helpful for ERG members.thank you Mr Jestine for uploading it.

    Likes(0)Dislikes(0)
  2. beh

    May 12, 2011 at 7:29 am

    HI MR GRANT
    it is very usful sepcially is done by a skilful lady
    thanks
    beh

    Likes(0)Dislikes(0)
  3. Amir Mukhtar

    May 19, 2011 at 3:50 am

    thanks you sir jestine to refresh etching and dying process of PCB making.

    I have seen and used two procedures of PCB making .

    1.... PCB make with Ferric chloride.
    2.... PCB make by halogen or Sun rays.

    No. 2 procedure, its very easy and clean process. in this procedure use a spray namely " PCB Etcher" German brand, which makes PCB through spray on print design at PCB then placed at Sun Beam Area. after an hour or two PCB has dry and ready to use. clean with thinner and drill holes before assemble.

    thanks you
    reagards
    Amir mukhtar

    Likes(0)Dislikes(0)
  4. admin

    May 20, 2011 at 12:18 am

    HI Amir,

    Thanks for the second method. Perhaps do you want to submit the second method to my new website which i have sent to you?

    Jestine

    Likes(0)Dislikes(0)

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Open

Close