Don't Miss

VCR EATS TAPES. THE MOST COMMON CAUSE -Part 2

By on February 6, 2016
VCR EAT TAPES

Check out part 2 about VCR Eats Tapes By Dave

 

Likes(10)Dislikes(2)

2 Comments

  1. Nasim

    April 26, 2020 at 12:39 am

    Hi Jestine
    I have sharp vcr midel vc 790 ET multi system I t was using it to transfer pal vhs tapes to dvds.
    Now when I insert the tape it go down stay there few seconds and come back it does like this few times and than stops. Also the head id not turning ON too.
    I think it is not detecting the the tape. I opened the tape carrier and checked all the micro switches are fine. There is small cct board in the bottom where the Tape sits and run i think this is for to detect the tape and also i checked the sensor embedded inthe small plastic stand which is also used to unlock spools. Sensor shows resistance. I also tried different tapes but still the problem is there. Would you please like me to suggest some thing help me to solve my problem.

    Nasim

    Likes(0)Dislikes(0)
    • Jestine Yong

      April 29, 2020 at 6:12 pm

      Hi Nasim,

      If your problem is auto eject perhaps check on the youtube link here to get some ideas.

      Jestine

      Likes(0)Dislikes(0)

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Open

Close