Don't Miss

Dead Bluetooth Player Repair

By on November 21, 2026
Dead Bluetooth Player Repair

This player was not switching on when it was sent to me, with  charging led on whenever it is connected to adptor.

Bluetooth Player Repair

I prime it open and examined its board, l noticed burnt track near on/off switch button,

which runs through under on/off switch,(red mark)

how to fix bluetooth player

so I soldered out switch and trace track to a tiny hole that goes through board to other side of board to positive pin of male usb A meant to play flash drive.

I then connected a joint wire between the two points.

fixing bluetooth player

When tested the on/off switch, it was shorted and battery too, since i don’t have same type of switch, I had to modify a bigger switch to replace on/off switch, also

fixing bluetooth player

replaced battery with new one,then assembled everything back,press on/off button, and player did on, paired it with phone  bluetooth and it play.

how to repair a broken bluetooth player

This is the finished repair work.

imoudu onwuwah

This article was prepared for you by Imoudu Onwumah from Nigeria. He is 62 years old and has just 3 years experience in electronics repairs. I started career in hotel industry as a chef, but then I was doing repairs only in electrical repairs as a hobbyist. In 2018, I decided to learn about electronics which through Jestine’s electronics e-books and holding my hand, am an electronics techie today.

Please give a support by clicking on the social buttons below. Your feedback on the post is welcome. Please leave it in the comments.

P.S- If you enjoyed reading this, click here to subscribe to my blog (free subscription). That way, you’ll never miss a post. You can also forward this website link to your friends and colleagues-thanks!

Note: You can read his previous article on Hisense Tv With Blinking Standby LED

Likes(8)Dislikes(1)

3 Comments

  1. Parasuraman S

    November 21, 2026 at 3:13 pm

    Glad to see an article from you after a gap, dear Imoudu! Many thanks for sharing this informative work.

    Likes(0)Dislikes(0)
  2. Albert van Bemmelen

    November 21, 2026 at 4:13 pm

    Luckily that the bigger MODE pushbutton still fitted nicely on the solder pads for a smaller button on this board Imoudu.

    Likes(1)Dislikes(0)
  3. Waleed Rishmawi

    November 21, 2026 at 5:57 pm

    good repair and thanks for sharing. have a blessed day

    Likes(0)Dislikes(0)

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Open

Close