Don't Miss
October 2012 Repair Newsletter
By Jestine Yong on October 7, 2012
If you are a first time visitor to this blog and wish to read the October 2012 repair newsletter about “How To Solve No power Problem In Fuji Xerox LaserJet Printer" then you can click HERE to subscribe to my monthly repair newsletter and you could also read all the previous repair newsletter too. See you in the other side!
Likes
(0)Dislikes
(0)
(0)Dislikes(0)
6 Comments
Leave a Reply
beh
October 7, 2012 at 4:14 am
HIMR YONG
thanks for this good repair
beh
Jestine Yong
October 7, 2012 at 11:13 am
Hi Beh,
You are welcome!
Jestine
Mohammed Kasim
October 7, 2012 at 6:53 am
Thank you so much for the news letter. Before two days I have repaired a Brother printer for the same complaint. I fist used a varister from a computer SMPS but it burns out immediately after powering on. I think it was a 110 volt varister since the computer SMPS is made to operate both on 110V and 220V. So I put another varister from an LCD TV. Now it is woriking fine. I have also replaced 3.15A fuse. Do you know the difference between 3A and 3.15A fuse?.
Jestine Yong
October 7, 2012 at 11:15 am
Hi Mohammed,
The different is the ampere. It depends on the design. Some draw heavier current will use the 3.15 amp.
Jestine
vijay
October 9, 2012 at 7:30 pm
how use signal injector? this is useful?.
Jestine Yong
October 9, 2012 at 9:05 pm
Hi Vijay,
It depends on which field you are in. If you troubleshoot audio equipment you can use inject the signal and see if there is any output. Other repair field not necessary have to use signal injection.
Jestine