About Isolation Transformer
By Jestine Yong on December 31, 2010
Likes
(1)Dislikes
(0)



2 Comments
Leave a Reply
Cancel replyThis site uses Akismet to reduce spam. Learn how your comment data is processed.
Latest News
-
Backlight LED Domes Found Lying Loose In SONY LED TV Model KLV32EX330
This was referred to by...
- Posted March 29, 2025
- 12
-
How To Fix A Dead Short Welding Machine
A welding technician brought...
- Posted March 29, 2025
- 12
-
Not Charging Solved In This Head Lamp Used For Service
These are two headlamps that I...
- Posted March 29, 2025
- 15
-
A Hand Blender That Works Fine But Has A Hissing Sound Repaired And Maintained
This hand blender was brought...
- Posted March 29, 2025
- 16
-
How To Test PWM Gate Drive Signal Pulse Using Single Bright LED
It is difficult to check...
- Posted March 22, 2025
- 27
-
Shorted Backlight LED Drained Battery In LUVLAP Breast Feed Pump
This breast pump was brought...
- Posted March 22, 2025
- 8
-
A Samsung TV with No Backlight Repaired and Maintained
This TV was brought to...
- Posted March 22, 2025
- 8
Henry Elcock
January 6, 2011 at 3:42 pm
Dear MR Young i have a problem with a panasonic TV. CT27G24A the 33 volts from the flyback that is supplying the tuner is low, i have tried two other tuners and voltage is still low if i remove the pin the 33 volts is suppilying it comes up to the correct voltage i want to know if a defective eprom iC can cause this problem .The TV has no Rasta no sound and no picture.THank you.
admin
January 6, 2011 at 11:39 pm
HI Henry,
Usually bad eeprom ic would not cause such problem unless it is shorted. Try trace backward from the 33 volt line and if you find any e-caps, try direct replace it and retest. If the filter cap tested good then directly replace the output diode because sometimes diode can be breaking down under load. Since you have replaced two tuners thus tuner was not the cause of the problem.
Jestine