All posts by Jestine Yong

• 
  Wster WS2911 Karaoke Mic

              Received Wster WS2911 Karaoke Mic, stating problem not working. Inspected unit found it powering ON, Speaker also working but Mic is not working. Tried by sliding the Mic Volume but no...

  • Posted February 22, 2025
  • 13
• 
  Cone Paper Found Popped Out In Speakers Of Samsung LED TV Model UA32J4303AKXZN

            This TV belonged to one of my colleagues in the hospital and was brought to me with the complaint that the sound output was very low. I set aside my pending work...

  • Posted February 22, 2025
  • 14
• 
  Failure Of Motor Control IC BA6209 In KENWOOD KX-880D Cassette Deck

              This antique cassette deck was brought to me by a new customer, referred to by one of my regulars. The complaint was that none of the functions worked, but lights were...

  • Posted February 22, 2025
  • 15
• 
  Completed Another Basic Electronics Repair Course for 12 Participants

  Completed today another Basic Electronics Repair level 1 course for 12 participants. Below is a video and photos taken during the 3 days course: Likes(13)Dislikes(0)

  • Posted February 21, 2025
  • 8
• 
  Dead Compo Board In DELL Computer Monitor Model D1918H Restored

              This monitor belonged to the hospital where I worked and was brought to me in dead condition. I pried open the front panel, and removed the back cover to expose the...

  • Posted February 15, 2025
  • 13
• 
  How To Make Mosquito Killer?

              Note: Keep away your children & pets from this circuit & take safety measure as required. For making Mosquito grabber we need two different size of Aluminum Mesh, there are total 3...

  • Posted February 15, 2025
  • 20
• 
  How To Fix A Rechargeable Fan

            This rechargeable table fan was brought to me with complaints of  not auto cutting off when charging, led continues blinking ever since he bought it and battery is now weak, and so...

  • Posted February 15, 2025
  • 7
• 
  This Repair Is About A CNC laser Engraver

              The customer had other people look at this CNC laser engraver and no one could get it the laser working. First thing to do was test to see the fault. So...

  • Posted February 15, 2025
  • 13