Don't Miss

Flyback Replacement Guide

By on February 11, 2009

If you would like to know some of the Monitor Flyback transformer replacement guide then click on Zic’s blog for more information (click on the photo). Please read also some of the previous post too using the google translation feature. When you are in the blog make sure you click on the “VIEW” to see the internal diagram of the flyback transformer.

flyback replacement



  1. Amit

    July 1, 2010 at 5:16 am

    Dear Sir, I have a LG monitor model 500, its voltage at collector of HOT is fluctuing from 46 to 176, if we remove HOT then the capacitor of 47mfd/160v was blows. Please suggest.

  2. admin

    July 1, 2010 at 8:33 am

    HI Amit,

    Without the HOT in certain monitor the B+ cap will blow. I suggest that you visit this link:


  3. Amit

    July 2, 2010 at 5:09 am

    Thanks Jestine, the link is very informative, my problem is that in this monitor i found that the B+ is varying. Highest it goes to 176v due to this HOT blows off. So I have disconnect B+ to flyback transformer and connect a 100 watt bulb to it. If I will disconnect a 5v and 7v supply at out put of SMPS then the voltage is comes to stable at 46v. These supply are connected to Microprocessor SAMSUNG N307A, and IC SAMSUNG U309 respectively. Please let me know the reason the increse of voltage to 176v(even if B+ to the flyback transformer is disconnected)

  4. admin

    July 2, 2010 at 8:31 am

    Hi Amit,

    Check the optoisolator circuit to see if there is any resistor that turn into high ohm.


  5. ravi sharma

    September 7, 2012 at 10:23 am

    dear sir,in lg color tv it runs in but after 5 minutes the light is deeming .i have checked boost supply nd heater voltage are good. the eht no. is 6174z-6006e.what is the crt defective?


Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Free Report