Don't Miss


No Sound In Telesonic RCR Repaired

By on May 29, 2020

 

 

 

 

 

 

how to repair telesonic radio

The complaint from my customer about this Telesonic RCR Radio was no sound. I took out my USB (below photo) and plugged it in and it can played but there was no sound even though the volume was already set to the maximum. This means, indeed the sound section was having problem

how to fix telesonic radio

I immediately went straight to the sound section and check on the speaker first before I start to troubleshoot on the audio circuit.

Measuring the Ohm value of the speaker confirmed that the speaker wire connection internally was already opened circuit.

how to fix and repair telesonic radio

However, when I checked on the outer part of the speaker as shown in the below photo, it seems to have low ohms reading:

speaker wire fixed

When I dismantled the speaker I found that the copper wire inside already damaged. Since I have new cooper wire, I soldered it and be able to fix the speaker.

speaker wire repair

The sound came back after fixing the speaker.

I really hope you can hear the sound but in this blog, you can’t hear anything because only photos posted! 

telesonic radio service and repair

Conclusion- Assuming if the speaker is working fine then the next step I need to do is to troubleshoot the audio circuit. It could be bad audio IC, improper DC supply voltage to the audio ic, dry joints, broken circuitry, no incoming signal and etc. Well, let me tell you that troubleshooting and repairing is fun and you will not get bored with it. There are so many things to learn in electronics troubleshooting. Alright, will see you again in the next repair article.

suranga

This article was prepared for you by Suranga Bandara who owns an Electronics repair shop in Anuradapura, Sri Lanka.




Please give a support by clicking on the social buttons below. Your feedback on the post is welcome. Please leave it in the comments. If you have electronic repair articles to share with us, please contact us HERE.

P.S-  If you enjoyed reading the above article, click here to subscribe to my blog (free subscription). That way, you’ll never miss a post. You can also forward this website link to your friends and colleagues-thanks!

Note: You may check out his previous post in the below links:

https://jestineyong.com/lg-dvd-player-shutdown-repaired/

 

Likes(60)Dislikes(0)

5 Comments

  1. Parasuraman S

    May 29, 2020 at 9:13 am

    Though the problem got solved very easy, one cannot do so as simple as that, unless it is an expert like you! Many thanks for sharing!

    Likes(1)Dislikes(0)
  2. Humberto

    May 29, 2020 at 9:44 am

    Good repair Suranga. Thanks for sharing this article.

    Likes(1)Dislikes(0)
  3. Albert van Bemmelen

    May 29, 2020 at 1:09 pm

    Wireless speakers, although electronically speaking are technically possible, still do not exist in the consumer world and possible require more energy to work without wires. Luckily these old electrodynamic speakers still can be fixes by reconnecting a broken wire this easy.

    Likes(2)Dislikes(0)
  4. david

    May 29, 2020 at 1:34 pm

    good job! usually will go check all the amplifier circuits first.
    next time i will check the speaker first

    Likes(1)Dislikes(0)
  5. yogesh Panchal

    May 29, 2020 at 6:25 pm

    Good job !Suranga

    Likes(1)Dislikes(0)

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Free Report