Logitech Mouse Pointer Freezes On The Monitor Screen Intermittently
One of my friends brought one computer mice for repair to me and complaining about mouse is working intermittent when he moves cursor on monitor screen cursor get freeze and get start work after tapping the mouse on the table.
So for testing connected this mouse to my setup it works for say 10 minute and started to stop the cursor moving.
So for Further diagnosis I have opened the mouse just remove one screw – flip top cover and slide forward little bit.
After opening I have started visual inspection……….
I have suspected some dry solder on the PCB but on inspection everything is seems to be Ok no dry solder or any physical damage is found.
I have removed everything out of the case and connected the mouse again on the setup for testing this time it works fine no freezing /hanging……I have put everything in the case again and checked it again start freezing intermittent…….
Now I suspected the cable this is 5 core cables. For intermittent problem you can’t confirm by checking continuity simple way is to cut this cable or replace the new cable and see.
Mostly these types of cables are damaged form either on end connector side or device side.
So I cut the cable from device side. Because when you moving the mouse
This is the side of cable which is getting bend frequently.
After Cutting the cable I have resoldered it & re assembled the mouse and connected on the setup again for testing this time Freeze / hanging has gone…………
This article was prepared for you by Yogesh Panchal who works as a Computer Hardware Engineer in Mumbai India.
P.S- Do you know of any your friends who would benefit from this content that you are reading now? If so, forward this website to your friends or you can invite your friends to subscribe to my newsletter for free in this Link.
Note: You can check his previous repair articles in the link below:
https://jestineyong.com/how-to-revive-any-dead-phone-battery/
Parasuraman S
August 28, 2020 at 9:48 pm
You are very determined to accomplish the mission irrespective of what comes to you for repair! A good quality every service engineer should emulate!
Yogesh Panchal
August 29, 2020 at 2:19 pm
Sir,
Thanks! for your encouraging words.
Waleed Rishmawi
August 28, 2020 at 10:54 pm
A job well done my friend. The cable does these kinds of faults.
Yogesh Panchal
August 29, 2020 at 2:24 pm
waleed,
For any equipment which required continuous movement for operating
My first suspect is always cable may be because stiffness.
Albert van Bemmelen
August 29, 2020 at 12:05 am
Cutting the cable in the problem area to get rid of the broken copper wire connection is the best solution here, since buying a new mouse cable is almost impossible! As only new mouses have new cables.
Yogesh Panchal
August 29, 2020 at 2:26 pm
Right Albert,
Eliminate suspected parts for intermittent problem is always time saving.
Derek Nathainel
August 30, 2020 at 1:09 am
I have encountered this problem many times usually the cable is at fault mostly from the end in which there is too much movement
Yogesh Panchal
August 30, 2020 at 3:55 pm
Derek Nathainel,
Stiffness of cable & bad quality of wires used inside are main cause.