Latest News

• The Important of Oscilloscope

    Under normal troubleshooting and repair i do not use oscilloscope. I will only use scope when i want to measure the waveform output from the IC. Assuming there is...

  • Posted October 12, 2007
  • 2
• Selamat Hari Raya

  Tomorrow is first syawal and wishing all of my muslim friends, readers and subscribers ” Selamat Hari Raya”. Muslims celebrate the festival of Aidilfitri – popularly known as Hari...

  • Posted October 12, 2007
  • 1
• Redesigned of My First E-book

  These few days i’d been redesigning my first E-book website www.findburntresistorvalue.com . This E-book had been in the market for the past 3 and a half years and i...

  • Posted October 11, 2007
  • 0
• Observe the Filter Capacitor Cap

    Whenever there is a problem in electronic equipment i would first look at the electronic board for dry joints, decayed glue, loose connection in connectors, bulged capacitors, burnt...

  • Posted October 10, 2007
  • 0
• Thanks for your support!

  Not long after i  launched my new E-book, I made lots of sales from it. My first buyer was from Australia and here are just some of the countries...

  • Posted October 8, 2007
  • 0
• At Last My Brand New E-book Is Ready

    It took me a month to finally complete the task of creating an E-book to sell it to  the  electronic repair market. The first book on “How to...

  • Posted October 6, 2007
  • 0
• About Bulged Electrolytic Capacitors

    Whenever you see a bulged electrolytic capacitors on any kind of electronic boards, don’t waste your time to measure or check it. Simply remove the capacitors and replace...

  • Posted October 5, 2007
  • 0
• Contrast Problem In CRT Monitor

    If CRT Monitor have contrast problem, the thing you must do is to adjust from the menu or button. Check the heater voltage make sure it should have about...

  • Posted October 4, 2007
  • 0